ICT FIRMWARE RELEASE NOTES
==========================

Products affected: ICT180-12I, ICT180-12B, ICT180-12IRC, ICT180-12BRC

Release date:      7-26-2011

Release type:      Production

Hardware version:  02

Firmware version:  v1.13

Preceding release: v1.12

File name:         ICT180-12I:		ICT180-12I_v113.cry
		   ICT180-12B:		ICT180-12B_v113.cry
		   ICT180-12IRC:	ICT180-12IRC_v113.cry
		   ICT180-12BRC:	ICT180-12BRC_v113.cry

------------------------------------------------------------------------------

v1.13 RELEASE NOTES
===================

- "Power Cycle" option added to ICT180-12IRC and ICT180-12BRC.
- The "Send Test E-mail" page now shows SMTP Error Messages.
- All Distribution Panel models will now send a Restart E-mail Notification when the Panel restarts, if e-mail is enabled.



UPGRADE INSTRUCTIONS
====================

Warning: If upgrading from Firmware v1.10 or earlier, all settings on the Distribution Panel will be reset to Factory Default Settings during the Firmware upgrade.

1.) Run the ICT Firmware Utility program
2.) In the "Device IP Address" box, type the remote IP address or host name of your Distribution Panel.
3.) In the "Port" box, type the UDP port number of your Distribution Panel. You can find this port number on the "Network Setup" page in your Distribution Panel's web site.
4.) In the "Password" box, type the password of your Distribution Panel.
5.) Click on the "Capture Device" button.
6.) With the Firmware Utility program still running, open your Web Browser program (such as Internet Explorer).
7.) Enter your Distribution Panel's remote IP address or host name into the address bar and log into the Distribution Panel web site.
8.) Go to the "Maintenance" page and click on the "Reset" button.
9.) Switch back to the Firmware Utility program. The program should now indicate that the Panel is now in Bootloader Mode.
10.) Click on the "File" button in the Firmware Utility program. Select the .cry Firmware file for your Distribution Panel.
11.) Click on the "Program Device" button. The upgrade will several minutes to complete.
12.) After the Firmware Utility program displays "Finished Programing", click on the "Reset Device" button.
13.) Close the Firmware Utility program. The firmware upgrade is now complete.